VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1428

DTC Code DTC Name
C1428 Motor Circuit Malfunction

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C1428 Motor Circuit Malfunction With the ABS motor relay off and the ABS motor fail-safe relay on, an open in the pump motor circuit continues for 2 seconds or more. Skid control ECU (brake actuator assembly)

WIRING DIAGRAM

Refer to DTCs C1361, C146C and C146D.

Click here

CAUTION / NOTICE / HINT

Note

When replacing the pump motor (brake actuator assembly), perform zero point calibration and store system information.

Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)


    1. A01MV8BC37
      *a

      Front view of wire harness connector

      (to Skid Control ECU (Brake Actuator Assembly))

      Make sure that there is no looseness at the locking part and the connecting part of the connectors.

    2. Disconnect the A15 skid control ECU (brake actuator assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A15-13 (GND2) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY for LHD: Click here
    REPLACE BRAKE ACTUATOR ASSEMBLY for RHD: Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)