VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1240

DTC Code DTC Name
C1240 Yaw Rate Sensor Discrimination

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C1240 Yaw Rate Sensor Discrimination The yaw rate sensor identification information stored in the skid control ECU (brake actuator assembly) is not consistent with the yaw rate sensor identification information sent via CAN communication continuously for 1 second or more.

  • Yaw rate sensor (yaw rate and acceleration sensor)

  • Skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

Note

When replacing the brake actuator assembly or yaw rate and acceleration sensor, perform zero point calibration and store system information.

Click here

PROCEDURE


  1. CHECK PART NUMBER (YAW RATE AND ACCELERATION SENSOR)


    1. Check that the part number of the installed yaw rate and acceleration sensor is correct.

      OK
      Yaw rate and acceleration sensor installed in the vehicle has the correct part number.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE YAW RATE AND ACCELERATION SENSOR Click here

    OK

  2. RECONFIRM DTC


    1. Clear the DTCs.

      Click here


      Chassis > ABS/VSC/TRC > Clear DTCs

    2. Turn the engine switch off.

    3. Turn the engine switch on (IG).

    4. Check if the same DTC is output.

      Click here


      Chassis > ABS/VSC/TRC > Trouble Codes
      Result
      Result Proceed to
      DTC C1240 is output. A
      DTC C1240 is not output. B

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY for LHD: Click here
    REPLACE BRAKE ACTUATOR ASSEMBLY for RHD: Click here

    B

    USE SIMULATION METHOD TO CHECK Click here