TIRE PRESSURE WARNING INITIATOR(for Rear Side) INSTALLATION

PROCEDURE

1. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR

   
   

   1. Install the rear tire pressure monitor initiator with the 2 nuts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Engage the grommet.

   3. Install the rear wheel house liner LH to its original position.

   4. Connect the connector.

2. INSTALL REAR WHEEL LH

   Torque:

   103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

3. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

4. INSTALL NO. 2 ROOM PARTITION COVER (for Fold Down Seat Type)

   Click here

5. INSTALL REAR SEAT SUB FLOOR PANEL (for Fold Down Seat Type)

   Click here

6. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fixed Seat Type)

   Click here

7. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fold Down Seat Type)

   Click here

8. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER

   Click here

9. INSTALL DECK SIDE TRIM BOX LH

   Click here

10. INSTALL SPARE WHEEL COVER TRAY (w/o Spare Tire)

    Click here

11. INSTALL SPARE WHEEL COVER TRAY LH (w/ Spare Tire)

    Click here

12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

13. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

14. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)

    Click here

15. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here