| DTC Code | DTC Name |
|---|---|
| C1785 | Steering Control ECU Communication Error |
DESCRIPTION
The absorber control ECU receives signals from the VGRS ECU (front steering control ECU) via CAN communication.
When there is a communication malfunction, the malfunction will be detected by the diagnosis function.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Note |
|---|---|---|---|---|---|
| C1785 | Steering Control ECU Communication Error | While the engine switch is on (IG), the VGRS ECU (front steering control ECU) malfunction signal is received for 5 seconds or more. |
|
Does not come on | w/ VGRS System |
CAUTION / NOTICE / HINT
Note
Before performing troubleshooting, inspect the connectors of related circuits.
If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first.
Before replacing the absorber control ECU, perform all of the following again: 1) symptom simulation ; 2) DTC inspection; and 3) GTS inspection (ECU Data List or Active Test Click here). If no malfunctions are found in other areas, replace the absorber control ECU.
When the absorber control ECU is replaced, switch to test mode and check that all test mode DTCs are cleared when their respective deletion conditions are met.
PROCEDURE
CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
Check for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here |
| A |
|
CHECK FOR DTC (VGRS SYSTEM)
Check for VGRS system malfunction DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
GO TO VGRS SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here |