REAR DIFFERENTIAL CARRIER ASSEMBLY(for 4GR-FSE) COMPONENTS
ILLUSTRATION
| *1 | TAIL EXHAUST PIPE ASSEMBLY | *2 | TAIL EXHAUST PIPE LH |
ILLUSTRATION
| *1 | REAR DIFFERENTIAL CARRIER ASSEMBLY | *2 | REAR UPPER DIFFERENTIAL MOUNT STOPPER |
| *3 | REAR LOWER DIFFERENTIAL MOUNT STOPPER | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part |  |
Do not apply lubricants to the threaded parts |
| *T1 | Bolt Type A: 95.1 N*m (970 kgf*cm, 70 ft.*lbf) Bolt Type B: 88.9 N*m (907 kgf*cm, 66 ft.*lbf) |
- | - |
ILLUSTRATION
| *1 | REAR DIFFERENTIAL BREATHER PLUG | *2 | REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR |
| *3 | REAR DIFFERENTIAL CARRIER | *4 | REAR DIFFERENTIAL CARRIER COVER |
| *5 | REAR DIFFERENTIAL CARRIER OIL SEAL | *6 | REAR DIFFERENTIAL CARRIER STRAIGHT PIN |
| *7 | REAR DIFFERENTIAL DRAIN PLUG | *8 | REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |
| *9 | REAR DIFFERENTIAL DRIVE PINION OIL SLINGER | *10 | REAR DIFFERENTIAL DUST DEFLECTOR |
| *11 | REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL | *12 | REAR DRIVE PINION COMPANION FLANGE |
| *13 | REAR DRIVE PINION FRONT TAPERED ROLLER BEARING | *14 | REAR DRIVE PINION NUT |
| *15 | BEARING CAP | *16 | REAR DIFFERENTIAL FILLER PLUG |
| *17 | GASKET | - | - |
| *T1 | Preload Adjust Torque: 337.8 N*m (3445 kgf*cm, 249 ft.*lbf) or less | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Hypoid gear oil LSD | - | - |
ILLUSTRATION
| *1 | DIFFERENTIAL RING GEAR | *2 | REAR DIFFERENTIAL CASE BEARING |
| *3 | REAR DIFFERENTIAL CASE SUB-ASSEMBLY | *4 | REAR DRIVE PINION REAR TAPERED ROLLER BEARING |
| *5 | DIFFERENTIAL DRIVE PINION | *6 | REAR DIFFERENTIAL SIDE GEAR SHAFT PLATE WASHER |
| *7 | REAR DIFFERENTIAL DRIVE PINION PLATE WASHER | *8 | REAR DIFFERENTIAL RING GEAR SET BOLT LOCK PLATE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Hypoid gear oil LSD | - | - |