REAR DIFFERENTIAL CARRIER ASSEMBLY(for 2GR-FSE) REMOVAL

PROCEDURE


  1. DRAIN DIFFERENTIAL OIL

    Click here

  2. REMOVE REAR DRIVE SHAFT ASSEMBLY


    1. Remove the rear drive shaft assembly LH and rear drive shaft assembly RH.

      Click here

  3. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  4. DISCONNECT TAIL EXHAUST PIPE ASSEMBLY

    Click here

  5. DISCONNECT TAIL EXHAUST PIPE LH

    Click here

  6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

    Note


    • Do not damage the installation surface when removing the rear differential carrier assembly.

    • The remaining oil may leak out when removing the rear differential carrier assembly.

    • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

    • Remove the bolts with the rear differential carrier assembly secured.


    1. B003TA6N02

      Support the rear differential carrier assembly with a jack.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

    2. Using a 12 mm hexagon wrench, remove the 3 bolts (B).

    3. Remove the 2 bolts (A), 2 rear upper differential mount stoppers, 2 rear lower differential mount stoppers and rear differential carrier assembly.

      Tech Tips

      As there are 2 types of bolts (A), the same type bolt must be used during removal and installation.

      B003WJ4C02
      *A Bolt Type A
      *B Bolt Type B