STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL STEERING KNUCKLE


    1. Install the steering knuckle to the front upper suspension arm assembly with the nut.

      Torque:
      87 N*m  { 887 kgf*cm, 64 ft.*lbf }

      Note

      Prevent oil from adhering to the threaded and tapered parts.

    2. Install a new clip.

      Note

      Further tighten the nut up to 60° if the holes for the clip are not aligned.

  2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY


    1. Install the front lower ball joint assembly to the steering knuckle with the 2 bolts.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  5. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  6. INSTALL FRONT DISC

    Click here

  7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  9. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  11. CHECK FOR SPEED SENSOR SIGNAL

    Click here