STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL STEERING KNUCKLE


    1. Install the steering knuckle to the front upper suspension arm assembly with the nut.

      Torque:
      87 N*m  { 887 kgf*cm, 64 ft.*lbf }

      Note

      Prevent oil from adhering to the threaded and tapered parts.

    2. Install a new clip.

      Note

      Further tighten the nut up to 60° if the holes for the clip are not aligned.

  2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY


    1. Install the front lower ball joint assembly to the steering knuckle with the 2 bolts.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  5. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  6. INSTALL FRONT DISC

    for 4GR-FSE: Click here

    for 2GR-FSE: Click here

  7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  9. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  11. CHECK FOR SPEED SENSOR SIGNAL

    Click here