FRONT AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


    1. Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 4 bolts.

      Torque:
      68.6 N*m  { 700 kgf*cm, 51 ft.*lbf }

  2. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  4. INSTALL FRONT DISC

    for 4GR-FSE: Click here

    for 2GR-FSE: Click here

  5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. CONNECT SKID CONTROL SENSOR WIRE


    1. Connect the skid control sensor wire connector to the front axle hub sub-assembly.

      Note

      Do not twist the skid control sensor wire when installing it.

  7. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. CHECK FOR SPEED SENSOR SIGNAL

    Click here