PARK / NEUTRAL POSITION SWITCH ADJUSTMENT

PROCEDURE


  1. SEPARATE TRANSMISSION CONTROL SHAFT LEVER RH


    1. Move the shift lever to N.

    2. Remove the nut and spring washer, and separate the transmission control shaft lever RH from the park/neutral position switch assembly.

  2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01MUDMC04
      *a Neutral Basic Line
      *b Groove

      Remove the bolt from the park/neutral position switch assembly.

    2. Clean the bolt and the bolt hole.

    3. Align the neutral basic line with the groove as shown in the illustration.

    4. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    5. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque:
      12.8 N*m  { 131 kgf*cm, 9 ft.*lbf }

    6. After the adjustment, perform the park/neutral position switch assembly operation check.

      Click here

  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH


    1. Install the transmission control shaft lever RH to the park/neutral position switch assembly with the spring washer and nut.

      Torque:
      15.7 N*m  { 160 kgf*cm, 12 ft.*lbf }