PROPELLER SHAFT ASSEMBLY(for 2GR-FSE, 8AR-FTS, 2GR-FKS) COMPONENTS
ILLUSTRATION
| *1 | ENGINE UNDER BRACE SUB-ASSEMBLY | *2 | FRONT NO. 1 FLOOR HEAT INSULATOR |
| *3 | NO. 1 FUEL TANK PROTECTOR | *4 | PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
| *5 | ADJUSTING WASHER | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |  |
Do not apply lubricants |
ILLUSTRATION
| *1 | NO. 1 CENTER SUPPORT BEARING ASSEMBLY | *2 | PROPELLER INTERMEDIATE SHAFT ASSEMBLY |
| *3 | SLIDING SHAFT BOOT | *4 | PROPELLER SHAFT ASSEMBLY |
| *5 | NO. 1 PROPELLER SHAFT DUST DEFLECTOR | *6 | NO. 2 PROPELLER SHAFT DUST DEFLECTOR |
| *7 | NO. 2 PROPELLER SHAFT DUST DEFLECTOR SNAP RING | *8 | ADJUSTING NUT |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part |  |
Molybdenum disulphide lithium base NLGI No. 2 |