CRUISE CONTROL MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT CRUISE CONTROL MAIN SWITCH


    1. w/o Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        A001KYGC03
        *a

        Component without harness connected

        (Cruise Control Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 3 (CCS) Cruise control switch (ON-OFF button) released 1 MΩ or higher
        Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
        +/RES 235 to 245 Ω
        -/SET 617 to 643 Ω
        CANCEL 1509 to 1571 Ω

        If the result is not as specified, replace the cruise control main switch.

    2. w/ Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        A0126KSC03
        *a

        Component without harness connected

        (Cruise Control Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 2 (R/N) Cruise control switch (ON/OFF button) not pressed 1 MΩ or higher
        MODE Below 2.5 Ω
        1 (ECC) - 3 (CCS) Cruise control switch (ON/OFF button) not pressed 1 MΩ or higher
        Cruise control switch (ON/OFF button) pressed Below 2.5 Ω
        +/RES 235 to 245 Ω
        -/SET 617 to 643 Ω
        CANCEL 1509 to 1571 Ω

        If the result is not as specified, replace the cruise control main switch.