LANE DEPARTURE ALERT SYSTEM, Diagnostic DTC:C1AA7

DTC Code DTC Name
C1AA7 Skid Control Buzzer Circuit

DESCRIPTION

The lane departure warning camera sends a buzzer request signal to the skid control buzzer assembly to sound the buzzer. When the lane departure warning camera detects a malfunction in the skid control buzzer circuit, the lane departure warning camera stores DTC C1AA7.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA7 Skid Control Buzzer Circuit

Both of the following conditions are met:


  • Skid control buzzer assembly on malfunction is detected for 240 ms or more.

  • Skid control buzzer assembly off malfunction is detected for 5 seconds or more.

  • Harness or connector

  • Skid control buzzer assembly

  • Lane departure warning camera

WIRING DIAGRAM

A01MXHIE04

CAUTION / NOTICE / HINT

Note


  • When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. INSPECT SKID CONTROL BUZZER ASSEMBLY


    1. Remove the skid control buzzer assembly.

      Click here

    2. Inspect the skid control buzzer assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE SKID CONTROL BUZZER ASSEMBLY Click here

    OK

  2. CHECK TERMINAL VOLTAGE (POWER SOURCE OF SKID CONTROL BUZZER ASSEMBLY)


    1. A01MV3QC04
      *a

      Front view of wire harness connector

      (to Skid Control Buzzer Assembly)

      Disconnect the K41 skid control buzzer assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K41-2 (IG1) - Body ground Engine switch on (IG) 11 to 14 V
      K41-2 (IG1) - Body ground Engine switch off Below 1 V
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL BUZZER ASSEMBLY - BATTERY)

    OK

  3. CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER ASSEMBLY - LANE DEPARTURE WARNING CAMERA)


    1. Disconnect the K41 skid control buzzer assembly connector.

    2. Disconnect the S9 lane departure warning camera connector.

    3. Disconnect the B8 millimeter wave radar sensor assembly connector (w/ Dynamic Radar Cruise Control System).

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K41-1 (BZ) - S9-8 (BZ) Always Below 1 Ω
      K41-1 (BZ) or S9-8 (BZ) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE LANE DEPARTURE WARNING CAMERA Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR