TCM(for 2GR) INSTALLATION

PROCEDURE


  1. INSTALL TCM


    1. Install the 2 brackets to the TCM with the 4 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }
    2. B003U4FC02
      *a Name Plate
      B003U82 Vehicle Front

      Install the TCM assembly to the engine room ECM box with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note


      • Install the TCM in the engine room ECM box with the name plate facing the inside of the vehicle.

      • Make sure that water and foreign matter do not enter the engine room ECM box when the engine room ECU cover is off.

      • If the TCM has been dropped or subjected to severe impact, or there any cracks, dents or other defects on the ECU housing, replace the TCM with a new one.

      • Make sure that the stud bolts are securely installed into the front and rear bolt holes.

    3. Connect the 2 TCM assembly connectors.

      Note

      Be sure to securely connect the 2 TCM connectors.

    4. Connect the 2 ECM connectors.

      Note

      Be sure to securely connect the 2 ECM connectors.

    5. Connect the connector holder and grommet to the engine room ECM box.

      Note

      Be sure to securely connect the claw.

    6. B003URV

      Connect the junction connector to the connector holder.

    7. Connect the 2 engine wire connectors to the connector holder.

  2. INSTALL ENGINE ROOM ECU COVER

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. RESET MEMORY

    Click here