SPEED SENSOR(for 8AR-FTS) INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION REVOLUTION SENSOR (SP2)

   
   

   1. Install the transmission revolution sensor (SP2) to the automatic transmission case sub-assembly with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   2. Connect the transmission revolution sensor (SP2) connector.

2. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

   
   

   1. Coat the O-ring with automatic transmission fluid.

   2. Using a T30 ''TORX'' socket wrench, install the transmission revolution sensor (NT) to the automatic transmission case sub-assembly with the bolt.

      Torque:

      6.8 N*m  { 69 kgf*cm, 60 in.*lbf }

      Note

      
      

      • When reusing the transmission revolution sensor (NT), inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the transmission revolution sensor (NT).

   3. Connect the transmission revolution sensor (NT) connector.

3. INSTALL TRANSMISSION REVOLUTION SENSOR (NC3)

   
   

   1. Install the transmission revolution sensor (NC3) to the automatic transmission case sub-assembly with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   2. Connect the transmission revolution sensor (NC3) connector.

4. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

   Click here