OIL PRESSURE SWITCHING VALVE INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY


    1. A01MY2RC05
      *1 O-Ring

      Apply a light coat of engine oil to the O-ring of the oil pressure switching valve assembly.

    2. Install the oil pressure switching valve assembly to the water inlet housing with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • When reusing the oil pressure switching valve assembly, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve assembly.

  2. INSTALL WATER BY-PASS PIPE ASSEMBLY

    Click here

  3. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

  4. INSTALL TURBOCHARGER SUB-ASSEMBLY

    Click here

  5. INSPECT FOR ENGINE OIL LEAK

    Click here