OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Remove any oil from the threads of the oil pressure sender gauge assembly.

    2. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

      Note


      • Install the oil pressure sender gauge assembly within 3 minutes after applying adhesive.

      • Do not let adhesive adhere to the oil hole.

    3. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

    4. Connect the oil pressure sender gauge assembly connector.

  2. CONNECT NO. 4 VENTILATION HOSE


    1. A01MWAAC02
      *a Upper Side
      *b 90°

      Install the No. 4 ventilation hose with the clip as shown in the illustration.

      Tech Tips

      Install the clip so that it is positioned as shown in the illustration.

  3. INSPECT FOR ENGINE OIL LEAK

    Click here