WASTE GATE VALVE ACTUATOR REMOVAL

PROCEDURE


  1. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front and Rear Catalyst)

    Click here

  2. REMOVE INLET COMPRESSOR ELBOW


    1. A01MXXG

      Disengage the clamp.

    2. Remove the 2 bolts and inlet compressor elbow from the turbocharger sub-assembly.

    3. A01MYIN

      Remove the inlet compressor gasket from the turbocharger sub-assembly.

  3. REMOVE WASTE GATE VALVE ACTUATOR WITH BRACKET ASSEMBLY

    Note

    After removal and installation of the waste gate valve actuator with bracket assembly, make sure to check the travel of the waste gate valve actuator.


    1. A01MVGV

      Remove the E-washer from the waste gate valve actuator with bracket assembly link pin.

      Note

      Do not reuse the E-washer.

    2. A01MV74

      Remove the 2 bolts and waste gate valve actuator with bracket assembly from the compressor housing with bearing sub-assembly.

      Note

      Do not drop or subject any component of the turbocharger sub-assembly to impact. If any component of the turbocharger sub-assembly is dropped or subjected to a strong impact, replace it with a new one.

      Tech Tips

      Adjustment washers may be installed between the waste gate valve actuator with bracket assembly and compressor housing with valve bearing sub-assembly.