FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    1. B003T8PC01
      *a

      Component without harness connected

      (Fuel Sender Gauge Assembly)

      Check that the float moves smoothly between F and E.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Float Level Specified Condition
      1 - 2 F 6.5 to 8.5 Ω
      Between F and E 6.5 to 199.4 Ω (Gradually changes)
      E 194.4 to 199.4 Ω

      • If the result is not as specified, replace the fuel sender gauge assembly.

  2. INSPECT NO. 2 FUEL SENDER GAUGE ASSEMBLY


    1. B003TILC01
      *a

      Component without harness connected

      (No. 2 Fuel Sender Gauge Assembly)

      Check that the float moves smoothly between F and E.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Float Level Specified Condition
      1 - 2 F 6.5 to 8.5 Ω
      Between F and E 6.5 to 216.1 Ω (Gradually changes)
      E 210.1 to 216.1 Ω

      • If the result is not as specified, replace the No. 2 fuel sender gauge assembly.