FUEL INJECTOR(for Direct Injection) INSPECTION

PROCEDURE


  1. INSPECT FUEL INJECTOR ASSEMBLY

    Note

    This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.


    1. B003WAJC01
      *a

      Component without harness connected

      (Fuel Injector Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 1.74 to 2.04 Ω

      If the result is not as specified, replace the fuel injector assembly.