FUEL PRESSURE SENSOR REMOVAL

PROCEDURE


  1. REMOVE FUEL RELIEF VALVE ASSEMBLY

    Click here

  2. REMOVE NO. 3 WATER BY-PASS PIPE


    1. B003UP5

      Slide the 2 clips and disconnect the inlet heater water hose A and outlet heater water hose A from the No. 3 water by-pass pipe.

    2. Disengage the wire harness clamp from the No. 3 water by-pass pipe.

    3. Remove the bolt.

    4. Slide the 2 clips and disconnect the No. 8 water by-pass hose, No. 9 water by-pass hose and remove the No. 3 water by-pass pipe.

  3. REMOVE FUEL PRESSURE SENSOR


    1. A0122XH

      Disconnect the fuel pressure sensor connector and wire harness clamp.

    2. Remove the fuel pressure sensor and gasket from the No. 1 fuel delivery pipe sub-assembly.