FUEL PRESSURE PULSATION DAMPER INSTALLATION

PROCEDURE


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. Apply a light coat of engine oil to the threads and gasket seating surface of the fuel pressure pulsation damper assembly.

    2. B003TKNC02
      *1 Gasket
      *2 Fuel Pressure Pulsation Damper Assembly
      *3 Fuel Tube Sub-assembly

      Install 2 new gaskets, the fuel tube sub-assembly and fuel pressure pulsation damper assembly to the fuel pump assembly.

    3. B003WHGC01
      *a Length of SST 52 mm (2.05 in.)
      *b Length of Torque Wrench 180 mm (7.09 in.)

      Using SST, tighten the fuel pressure pulsation damper assembly to the fuel pump assembly.

      SST
      09612-24014   ( 09617-24011 )
      Torque:
      without SST [Torque (N*m (kgf*cm, ft.*lbf))]
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }
      with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]
      31 N*m  { 316 kgf*cm, 23 ft.*lbf }

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 52 mm (2.05 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

  2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  3. CONNECT NO. 2 VENTILATION HOSE

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSPECT FOR FUEL LEAK

    Click here

  6. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here