INJECTOR DRIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time maybe required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  4. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  5. REMOVE INLET NO. 1 AIR CLEANER

    Click here

  6. REMOVE NO. 1 ENGINE COVER


    1. B003UNT

      Remove the 3 clips and No. 1 engine cover from the timing chain cover sub-assembly.

  7. REMOVE INJECTOR DRIVER


    1. B003WCQC01
      *a Lock Lever
      *b Lock
      *c Connector (with Lock)

      Push the lock and move each lock lever in the direction indicated by the arrow to disconnect the 3 connectors (with lock) from the injector driver.

    2. Disconnect the injector driver connector.

    3. B003TW5C01
      B003WAF Bolt
      B003U82 Nut

      Remove the bolt, 2 nuts and injector driver from the timing chain cover sub-assembly.

      Note

      Be careful not to drop or strike the injector driver.