FUEL INJECTOR(for Port Injection) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE INTAKE MANIFOLD

    Click here

  5. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

    Click here

  6. DISCONNECT FUEL TUBE SUB-ASSEMBLY

    Note

    Remove any foreign matter on the fuel tube connector and fuel pipe before performing this work.


    1. Disconnect the fuel tube sub-assembly from the fuel delivery pipe.


      1. B003WXSC02
        *a Retainer
        *b Fuel Tube Connector
        *c Nylon Tube
        *d O-ring
        *e Fuel Pipe
        B003WAF Pull out
        B003U82 Pull off

        Pull out the retainer to disengage the lock claws and pull off the fuel tube connector.

        Note

        Be sure to disconnect the fuel tube connector by hand.

      2. If the fuel tube connector and fuel pipe are stuck, push and pull the fuel tube connector to release it. Pull the fuel tube connector off of the fuel pipe carefully.

        Note


        • Be sure to disconnect the fuel tube connector by hand.

        • Do not scratch or allow any foreign matter to get on the parts when disconnecting them as the fuel tube connector has O-rings that seal the pipe (fuel pipe).

        • Do not bend, twist, pinch or kink the nylon tube.

      3. Check that there is no foreign matter on the sealing surfaces of the disconnected fuel lines. Clean them if necessary.

      4. Cover the disconnected fuel pipe and fuel tube connector with plastic bags to prevent damage and contamination.

  7. REMOVE FUEL DELIVERY PIPE


    1. B003X28

      Disengage the 3 clamps to disconnect the No. 6 engine wire from the fuel delivery pipe.

    2. B003TXK

      Disconnect the 4 port fuel injector assembly connectors to remove the No. 6 engine wire.

    3. B003WB8

      Remove the 2 bolts and fuel delivery pipe with the 4 port fuel injector assemblies from the cylinder head sub-assembly.

      Note

      Be careful not to drop the port fuel injector assemblies when removing the fuel delivery pipe.

    4. B003X7D

      Remove the 2 fuel delivery spacers from the cylinder head sub-assembly.

    5. B003UJB

      Remove the 4 injector vibration insulators from the cylinder head sub-assembly.

  8. REMOVE PORT FUEL INJECTOR ASSEMBLY


    1. B003T6C

      Pull the 4 port fuel injector assemblies out of the fuel delivery pipe.

    2. Remove the O-ring from each port fuel injector assembly.

    3. Attach a tag or label with the corresponding cylinder number to each port fuel injector assembly so that they can be installed to their original locations.

      Note

      Cover the port fuel injector assemblies with plastic bags to prevent damage and contamination.