REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B003WNCE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. B003TTB

      Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and crank angle sensor plate.

  3. REMOVE REAR ENGINE OIL SEAL


    1. B003T2YC03
      *a Cut Position
      *b Protective Tape

      Using a knife, cut through the oil seal lip.

    2. Using a screwdriver with its tip taped, pry out the oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.