FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new timing chain case oil seal.

      Note

      Keep the lip free of foreign matter.

    2. B003VAHC02
      *a 0 to 1.0 mm

      Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain case edge.

      SST
      09223-22010
      09506-35010

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. Install the crankshaft timing gear key to the key groove.

  3. INSTALL CRANKSHAFT PULLEY


    1. B003SYAC08
      *a Hold
      *b Turn

      Align the crankshaft timing gear key with the key groove of the crankshaft pulley, and slide on the crankshaft pulley.

    2. Using SST, install the crankshaft pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

  4. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY

    Click here

  5. INSTALL NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

    Click here

  6. INSTALL FAN AND GENERATOR V BELT

    Click here

  7. INSTALL FAN SHROUD

    Click here

  8. ADD ENGINE OIL

    Click here

  9. INSPECT ENGINE OIL LEVEL

    Click here

  10. INSPECT FOR OIL LEAK

    Click here