FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. DRAIN ENGINE OIL

    Click here

  2. REMOVE FAN SHROUD

    Click here

  3. REMOVE FAN AND GENERATOR V BELT

    Click here

  4. REMOVE NO. 1 WATER BY-PASS PIPE (w/ Oil Cooler)

    Click here

  5. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY

    Click here

  6. REMOVE CRANKSHAFT PULLEY


    1. B003WTXC06
      *a Hold
      *b Turn

      Using SST, loosen the crankshaft pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. B003V19C09
      *a Hold
      *b Turn

      Tighten the crankshaft pulley bolt to 2 or 3 threads of the crankshaft.

    3. Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply grease to the threads and tip of SST (center bolt) prior to use.

  7. REMOVE CRANKSHAFT TIMING GEAR KEY


    1. B003W41

      Remove the crankshaft timing gear key of the key groove.

  8. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. B003W4HC02
      *a Protective Tape

      Using a screwdriver with its tip taped, pry out the timing gear case or timing chain case oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.