FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE FAN SHROUD ASSEMBLY

    Click here

  2. REMOVE V-RIBBED BELT

    Click here

  3. DISCONNECT WIRE HARNESS


    1. B003VJ1

      Disconnect the engine oil pressure switch assembly connector.

    2. Remove the bolt and disconnect the wire harness.

  4. REMOVE CRANKSHAFT PULLEY


    1. B003WTXC01
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley and loosen the crankshaft pulley bolt until only 2 or 3 threads are screwed into the crankshaft.

      SST
      09330-00021   ( 09213-70020 )
    2. B003V19C01
      *a Hold
      *b Turn

      Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05010, 09954-05021 )

      Tech Tips

      Apply molybdenum grease to the threads and tip of SST (center bolt) prior to use.

  5. REMOVE CRANKSHAFT TIMING GEAR KEY


    1. B003X0XC03
      *1 Protective Tape

      Using a screwdriver, remove the crankshaft timing gear key from the crankshaft groove.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. B003T8IC03
      *1 Protective Tape

      Using a screwdriver, pry out the timing gear case or timing chain case oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.