REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. Clean the crankshaft and engine rear oil seal retainer.

    2. Apply MP grease to the lip of a new engine rear oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal section.

    3. B003UY3C03
      *a Standard depth

      Using SST and a hammer, tap in the engine rear oil seal until its surface is flush with the engine rear oil seal retainer edge.

      SST
      09223-15030   ( 09951-07150 )
      Standard depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap in the engine rear oil seal at an angle.

      • Do not tap in the engine rear oil seal more than necessary.

      • Do not deform the engine rear oil seal.

      • Wipe off extra MP grease on the crankshaft.

  2. INSTALL DRIVE PLATE


    1. B003X40E02

      Using SST, hold the crankshaft pulley.

      SST
      09330-00021   ( 09213-70020 )

    2. Clean the 8 bolts and 8 bolt holes.

    3. B003WYDC02
      *1 Pin Hole
      *2 Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. B003U5KC01
      *1 Drive Plate
      *2 Rear Drive Plate Spacer
      B003WAF Transmission Side

      Install the drive plate and rear drive plate spacer onto the crankshaft.

      Tech Tips

      Make sure the installation direction of the drive plate and the rear drive plate spacer.

    5. B003U7BC50
      *1 Adhesive

      Apply a few drops of adhesive to 2 or 3 threads of the 8 bolt tips.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note

      Install the bolt within 3 minutes after applying adhesive.

    6. B003TAMN02

      In several steps, uniformly tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83.5 N*m  { 851 kgf*cm, 62 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSPECT DRIVE PLATE

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  5. INSPECT FOR OIL LEAK

    Click here