STARTER(w/o Stop And Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD (for RHD)

  3. SECURE STEERING WHEEL (for RHD)

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE ENGINE UNDER COVER

    Click here

  6. REMOVE FRONT SUSPENSION MEMBER BRACE

    Click here

  7. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  8. SEPARATE STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY (for RHD)

    Click here

  9. REMOVE STARTER ASSEMBLY


    1. Disconnect the starter assembly connector.

    2. B003WH3

      Open the terminal cap.

    3. Remove the nut and disconnect terminal 30.

    4. B003VK3

      Remove the 2 bolts and starter assembly.