OIL PUMP COMPONENTS
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | ENGINE WIRE | *2 | FUEL PUMP ASSEMBLY |
| *3 | INTAKE AIR SURGE TANK ASSEMBLY | *4 | NO. 1 FUEL PIPE SUB-ASSEMBLY |
| *5 | FUEL MAIN TUBE CONNECTOR | *6 | FUEL PUMP LIFTER ASSEMBLY |
| *7 | FUEL PUMP LIFTER GUIDE | *8 | FUEL PUMP SPACER GASKET |
| *9 | NO. 2 WATER BY-PASS PIPE | *10 | NO. 2 SURGE TANK STAY |
| *11 | AIR SURGE TANK TO INTAKE MANIFOLD GASKET | *12 | VENTILATION HOSE ASSEMBLY |
| *13 | PURGE VALVE (NO. 1 VACUUM SWITCHING VALVE ASSEMBLY) | *14 | WATER BY-PASS HOSE |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with Union nut wrench |
| ● | Non-reusable part |  |
Do not apply lubricants to the threadedparts |
ILLUSTRATION
| *1 | FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY | *2 | INTAKE MANIFOLD |
| *3 | NO. 1 FUEL TUBE SUB-ASSEMBLY | *4 | NO. 2 FUEL TUBE SUB-ASSEMBLY |
| *5 | NO. 5 ENGINE WIRE | *6 | NO. 6 ENGINE WIRE |
| *7 | NO. 7 ENGINE WIRE | *8 | NO. 8 ENGINE WIRE |
| *9 | NO. 1 FUEL DELIVERY PIPE SPACER | *10 | INJECTOR VIBRATION INSURATOR |
| *11 | INTAKE MANIFOLD TO HEAD GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | w/o Oil Cooler | *B | w/ Oil Cooler |
| *1 | IGNITION COIL ASSEMBLY | *2 | NO. 1 WATER BY-PASS PIPE |
| *3 | NO. 2 IDLER PULLEY SUB-ASSEMBLY | *4 | NO. 2 WATER BY-PASS HOSE |
| *5 | NO. 2 WATER BY-PASS HOSE ASSEMBLY | *6 | NO. 3 WATER BY-PASS HOSE |
| *7 | NO. 6 WATER BY-PASS HOSE | *8 | OIL FILTER BRACKET SUB-ASSEMBLY |
| *9 | V-RIBBED BELT TENSIONER ASSEMBLY | *10 | WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
| *11 | WATER OUTLET SUB-ASSEMBLY | *12 | WATER PUMP PULLEY |
| *13 | WIRE HARNESS CLAMP BRACKET | *14 | O-RING |
| *15 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CYLINDER HEAD COVER SUB-ASSEMBLY | *2 | NO. 1 ENGINE COVER SUB-ASSEMBLY |
| *3 | SPARK PLUG TUBE GASKET | *4 | VVT SENSOR (for Intake Side of Bank 1) |
| *5 | VVT SENSOR (for Exhaust Side of Bank 1) | *6 | CYLINDER HEAD COVER GASKET |
| *7 | CAMSHAFT BEARING CAP OIL HOLE GASKET RH | *8 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Toyota Genuine Adhesive 1324, ThreeBond 1324 or equivalent | ★ | Precoated part |
ILLUSTRATION
| *1 | CYLINDER HEAD COVER SUB-ASSEMBLY LH | *2 | NO. 1 ENGINE COVER SUB-ASSEMBLY |
| *3 | SPARK PLUG TUBE GASKET | *4 | OIL FILLER CAP SUB-ASSEMBLY |
| *5 | GASKET | *6 | CYLINDER HEAD COVER GASKET |
| *7 | CAMSHAFT BEARING CAP OIL HOLEGASKET LH | *8 | VVT SENSOR (for Intake Side of Bank 2) |
| *9 | VVT SENSOR (for Exhaust Side of Bank 2) | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Toyota Genuine Adhesive 1324, ThreeBond 1324 or equivalent | ★ | Precoated part |
ILLUSTRATION
| *1 | ENGINE OIL LEVEL SENSOR | *2 | NO. 2 OIL PAN SUB-ASSEMBLY |
| *3 | OIL LEVEL SENSOR BRACKET | *4 | OIL PAN SUB-ASSEMBLY |
| *5 | OIL STRAINER SUB-ASSEMBLY | *6 | WIRE HARNESS CLAMP BRACKET |
| *7 | OIL PAN DRAIN PLUG | *8 | O-RING |
| *9 | CLIP | *10 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 1) | *2 | CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 2) |
| *3 | CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1) | *4 | CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 2) |
| *5 | CRANKSHAFT PULLEY | *6 | TIMING CHAIN CASE OIL SEAL |
| *7 | TIMING CHAIN COVER PLATE | *8 | TIMING CHAIN COVER SUB-ASSEMBLY |
| *9 | OIL PUMP GASKET | *10 | TIMING GEAR OR CHAIN COVER PLATE GASKET |
| *11 | O-RING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | |
Toyota Genuine Adhesive 1324, ThreeBond 1324 or equivalent |
 |
MP grease | |
Do not apply lubricants to the threadsparts |
ILLUSTRATION
| *1 | OIL PUMP COVER | *2 | OIL PUMP RELIEF VALVE |
| *3 | TIMING CHAIN COVER SUB-ASSEMBLY | *4 | DRIVE ROTOR |
| *5 | DRIVEN ROTOR | *6 | RELIEF VALVE PLUG |
| *7 | RELIEF VALVE SPRING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |