OIL PRESSURE SWITCH ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:


  • B003TK2

    When working near the engine room while the engine has started or the power source mode is engine switch on (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.

  • Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.

  • B003TYQC21
    *a High temperature areas

    Do not touch the engine or exhaust manifold sub-assembly when they are hot.

  • Touching the engine or exhaust manifold sub-assembly when they are hot could result in burns.

PROCEDURE


  1. REMOVE ENGINE UNDER COVER

    Click here

  2. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. Disconnect the engine oil pressure switch assembly connector.

    2. Start the engine.

    3. B003WC5

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Switch body Idling 10 kΩ or higher
      1 - Switch body Engine stopped Below 1 Ω

      If the result is not as specified, replace the engine oil pressure switch assembly.

    4. Connect the engine oil pressure switch assembly connector.

  3. INSTALL ENGINE UNDER COVER

    Click here