OIL PUMP COMPONENTS
ILLUSTRATION
| *1 | COMPRESSOR AND MAGNETIC CLUTCH | *2 | ENGINE WIRE |
| *3 | V-RIBBED BELT | *4 | GENERATOR ASSEMBLY |
| *5 | NO. 2 ENGINE COVER | *6 | V-RIBBED BELT TENSIONER ASSEMBLY |
| *7 | BRACKET | - | - |
 |
N*m (kgf*cm, ft*lbf) : Specified torque | - | - |
ILLUSTRATION
| *1 | IGNITION COIL ASSEMBLY | *2 | INJECTOR DRIVER |
| *3 | NO. 1 ENGINE COVER | *4 | NO. 2 IDLER PULLEY SUB-ASSEMBLY |
| *5 | WATER PUMP PULLEY | *6 | NO. 2 IDLER PULLEY COVER PLATE |
| *7 | FUEL TUBE SUB-ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | - | - |
ILLUSTRATION
| *1 | NO. 2 OIL PAN SUB-ASSEMBLY | *2 | OIL PAN SUB-ASSEMBLY |
| *3 | OIL STRAINER SUB-ASSEMBLY | *4 | OIL PAN DRAIN PLUG |
| *5 | GASKET | *6 | O-RING |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | WATER INLET | *2 | NO. 3 WATER BY-PASS HOSE |
| *3 | NO. 4 WATER INLET BY-PASS HOSE | *4 | NO. 2 WATER BY-PASS HOSE |
| *5 | WATER OUTLET PIPE O-RING | *6 | NO. 6 WATER BY-PASS HOSE |
| *7 | NO. 1 WATER INLET HOUSING GASKET | *8 | RADIATOR RESERVE TANK HOSE |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CYLINDER HEAD COVER SUB-ASSEMBLY | *2 | CYLINDER HEAD COVER SUB-ASSEMBLY LH |
| *3 | NO. 1 OIL PIPE | *4 | NO. 2 OIL PIPE |
| *5 | SPARK PLUG TUBE GASKET | *6 | SEAL WASHER |
| *7 | CYLINDER HEAD COVER GASKET | *8 | GASKET |
| *9 | OIL CONTROL VALVE FILTER RH | *10 | OIL CONTROL VALVE FILTER LH |
| *11 | CYLINDER HEAD COVER GASKET LH | *12 | OIL PIPE UNION |
| *13 | OIL CHECK VALVE BOLT | - | - |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
ILLUSTRATION
| *1 | CRANKSHAFT PULLEY | *2 | TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
| *3 | TIMING CHAIN OR BELT COVER SUB-ASSEMBLY | *4 | WIRE HARNESS CLAMP BRACKET |
| *5 | GASKET | - | - |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | ● | Non-reusable part |
 |
MP Grease |  |
Do not apply lubricants to the threaded parts |
| *T1 | Type A:250 N*m (2549 kgf*cm, 184 ft.*lbf) Type B:260 N*m (2651 kgf*cm, 192 ft.*lbf) |
- | - |
ILLUSTRATION
| *1 | OIL PUMP COVER | *2 | OIL PUMP RELIEF VALVE |
| *3 | OIL PUMP ROTOR SET | *4 | TIMING CHAIN COVER SUB-ASSEMBLY |
| *5 | OIL PUMP RELIEF VALVE SPRING | *6 | OIL PUMP RELIEF VALVE PLUG |
| |
N*m (kgf*cm, ft*lbf) : Specified torque | - | - |