OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. Clean and degrease the threads of the engine oil pressure switch assembly.

    2. A001HX7C03
      *1 Adhesive 1324

      Apply adhesive 1324 to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note


      • Install the engine oil pressure switch assembly within 3 minutes after applying adhesive.

      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

    3. B003U1KC02
      *a Type A
      *b Type B

      Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:
      Type A
      14.7 N*m  { 150 kgf*cm, 11 ft.*lbf }
      Type B
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    4. Connect the engine oil pressure switch assembly connector.

  2. ADD ENGINE OIL

    Click here

  3. INSPECT ENGINE OIL LEVEL

    Click here

  4. INSPECT FOR ENGINE OIL LEAK

    Click here

  5. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  6. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here