OIL PRESSURE SWITCH ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE ENGINE UNDER COVER

    Click here

  2. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. Disconnect the engine oil pressure switch assembly connector.

    2. Start the engine.

    3. B003WC5

      Measure the resistance according to the value(s) in the table below.

      CAUTION:

      Be careful of the V-ribbed belt when measuring with the engine running.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Switch body Idling 10 kΩ or higher
      1 - Switch body Engine stopped Below 1 Ω

      If the result is not as specified, replace the engine oil pressure switch assembly.

    4. Reconnect the engine oil pressure switch connector.

  3. INSTALL ENGINE UNDER COVER

    Click here