ENGINE SWITCH INSPECTION

PROCEDURE


  1. INSPECT ENGINE SWITCH


    1. B003UCOC03
      *a

      Component without harness connected

      (Engine Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition

      5 (SS1) - 6 (AGND)

      1 (SS2) - 6 (AGND)

      		 Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the engine switch indicator light.

    2. Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      		 Illuminates

      Tech Tips


      • If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.

      • If the voltage is too low, the engine switch indicator light will not illuminate.

      If the result is not as specified, replace the engine switch.