ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

   Tech Tips

   Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (w/ Canister Pump Module).

   Click here

   
   

   1. Install a new gasket onto the engine coolant temperature sensor.

   2. Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor to the rear water by-pass joint.

      Torque:

      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench.

      Click here

   3. Connect the engine coolant temperature sensor connector.

2. CONNECT WATER BY-PASS HOSE

   
   

   1. Connect the water by-pass hose to the rear water by-pass joint and slide the clip to secure it.

3. INSTALL FUEL PRESSURE SENSOR

   Click here

4. PERFORM INITIALIZATION (w/ Canister Pump Module)

   
   

   1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Click here