IGNITION COIL AND SPARK PLUG INSTALLATION

PROCEDURE


  1. INSTALL SPARK PLUG

    Tech Tips

    Perform "Inspection After Repair" after replacing a spark plug (w/ Canister Pump Module).

    Click here


    1. Install the 6 spark plugs to the cylinder head sub-assembly.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note

      If a spark plug has been struck or dropped, replace it.

      Tech Tips

      Install the same parts to their original positions.

  2. INSTALL IGNITION COIL ASSEMBLY

    Tech Tips

    Perform "Inspection After Repair" after replacing an ignition coil assembly (w/ Canister Pump Module).

    Click here


    1. Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly with the 6 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Install the same parts to their original positions.

    2. Connect the 6 ignition coil assembly connectors.

    3. A01MWYPN01

      Connect the ignition coil cover bracket to the cylinder head cover sub-assembly LH with the 2 bolts.

      Torque:
      Bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      Bolt B
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    4. Connect the wire harness to the cylinder head cover sub-assembly with the 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  4. PERFORM INITIALIZATION (w/ Canister Pump Module)


    1. Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.

      Click here