THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE CENTER NO. 4 ENGINE UNDER COVER

    Click here

  3. DRAIN ENGINE COOLANT

    Click here

  4. REMOVE INTAKE AIR SOUND CREATOR

    Tech Tips

    Only perform this procedure when replacement of the intake air sound creator is necessary.


    1. B003UIQ

      Loosen the hose clamp.

    2. Remove the bolt and intake air sound creator from the air cleaner cap with air cleaner hose.

  5. DISCONNECT NO. 2 VENTILATION HOSE


    1. B003W1B

      Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B003TTA

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disconnect the wire harness clamp from the air cleaner cap with air cleaner hose.

    3. B003W9Q

      Disconnect the No. 2 fuel vapor feed hose clamp from the air cleaner cap with air cleaner hose.

    4. B003T4O

      Disconnect the union to check valve hose from the air cleaner cap with air cleaner hose (for RHD).

    5. B003X1F

      Release the 4 clamps.

    6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  7. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B003W7S

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake air surge tank assembly.

    3. B003WGRC01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

  8. REMOVE THROTTLE BODY GASKET


    1. Remove the throttle body gasket from the intake air surge tank assembly.