REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A01MXG2C01
      *a Depth

      Using SST, evenly tap in the rear engine oil seal until the seal is flush with the edge of the cylinder block.

      SST
      09223-15030   ( 09951-07150 )
      Standard depth
      -0.45 to 0.45 mm (-0.0177 to 0.0177 in.)

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01MXONN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the bolts and their installation holes.

    3. A01MYJQC02
      *a Pin Hole
      *b Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01MUCQC01
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B003WAF Automatic Transmission Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Note

      As the rear drive plate spacer and the drive plate and ring gear sub-assembly are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. A01MW56N01

      Install and uniformly tighten new 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. CONNECT NO. 2 RADIATOR HOSE SUB-ASSEMBLY

    Click here

  5. ADD ENGINE COOLANT

    Click here

  6. INSPECT FOR COOLANT LEAK

    Click here

  7. INSPECT FOR ENGINE OIL LEAK

    Click here

  8. INSTALL ENGINE UNDER COVER

    Click here