CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring.

      Note

      If reusing the crankshaft position sensor, check the O-ring.

    2. B003U7BC95
      *a Adhesive

      Apply adhesive to 2 or 3 threads of a new bolt.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    3. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.

      • If the crankshaft position sensor has been struck or dropped, replace it.

    4. Connect the crankshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here

  3. INSTALL ENGINE UNDER COVER

    Click here