CAMSHAFT POSITION SENSOR REMOVAL

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  3. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    1. B003VK1

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

  4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    1. B003T9D

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

  5. DISCONNECT ENGINE WIRE


    1. B003WZJ

      Disengage the clamp.

    2. Disconnect the 2 camshaft timing oil control solenoid assembly connectors and water inlet with thermostat sub-assembly connector.

    3. Remove the bolt to disconnect the engine wire from the timing chain cover assembly.

    4. B003TDV

      Disengage the 3 clamps.

    5. Remove the 2 nuts to disconnect the engine wire from the cylinder head cover sub-assembly LH.

    6. Disconnect the 2 VVT sensor connectors and 2 ignition coil assembly connectors.

  6. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    1. B003WB5

      Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.

  7. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    1. B003U3T

      Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.