THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE INTAKE AIR SOUND CREATOR

    Tech Tips

    Only perform this procedure when replacement of the intake air sound creator is necessary.


    1. B003UIQ

      Loosen the hose clamp.

    2. Remove the bolt and intake air sound creator from the air cleaner cap with air cleaner hose.

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B003VZD

      Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

    2. B003V2N

      Disconnect the mass air flow meter sub-assembly connector.

    3. Disconnect the wire harness clamp from the air cleaner cap with air cleaner hose.

    4. B003WV1

      Disengage the clamp to disconnect the fuel vapor feed hose from the air cleaner cap with air cleaner hose.

    5. B003VI6

      Release the 4 clamps.

    6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  5. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B003UUP

      Slide the clip and disconnect the No. 16 water by-pass hose from the throttle body with motor assembly.

    2. B003UYD

      Disconnect the throttle body with motor assembly connector.

    3. Remove the 4 bolts and separate the throttle body with motor assembly from the intake air surge tank assembly.

    4. B003VJR

      Slide the clip and disconnect the water by-pass hose to remove the throttle body with motor assembly.

  6. REMOVE THROTTLE BODY GASKET


    1. B003WCX

      Remove the throttle body gasket from the intake air surge tank assembly.