AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1)

    Tech Tips

    Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

    Click here


    1. B003U9LC01
      *A for LHD
      *B for RHD
      *a Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH (TWC: Front Catalyst).

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Engage the 2 clamps and connect the air fuel ratio sensor connector.

  2. INSTALL AIR FUEL RATIO SENSOR (for Bank 2)

    Tech Tips

    Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

    Click here


    1. B003TIJC01
      *A for LHD
      *B for RHD
      *a Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH (TWC: Front Catalyst).

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Engage the clamp and connect the air fuel ratio sensor connector.

  3. CONNECT NO. 3 ENGINE ROOM RELAY BLOCK


    1. Connect the No. 3 engine room relay block to the vehicle body with the bolt and nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  4. INSTALL BATTERY TRAY (for LHD)


    1. Install the battery tray with the 3 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. INSTALL BATTERY TRAY (for RHD)


    1. Install the battery tray with the 3 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Engage the clamp to connect the wire harness to the battery tray.

  6. INSTALL POWER STEERING ECU ASSEMBLY


  7. INSPECT FOR EXHAUST GAS LEAK

    Click here

  8. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing an air fuel ratio sensor.

      Click here