4GR-FSE ENGINE CONTROL SERVICE DATA

SPARK PLUG
Standard Insulation Resistance Spark plug (terminal part) - Body ground 10 MΩ or higher
Spark Plug Type DENSO made FK20HBR11
Maximum Electrode Gap for Used Spark Plug 1.4 mm (0.0551 in.)
Standard Electrode Gap for New Spark Plug 1.0 to 1.1 mm (0.0394 to 0.0433 in.)
CAMSHAFT TIMING OIL CONTROL VALVE
Standard Resistance 20 °C (68 °F) 6.9 to 7.9 Ω
THROTTLE BODY WITH MOTOR ASSEMBLY
Standard Throttle Valve Opening Percentage Shift lever in N 60% or higher
Standard Resistance 20 °C (68 °F) 0.3 to 100 Ω
ACCELERATOR PEDAL SENSOR ASSEMBLY
Standard Voltage (Accele Sensor Out No. 1) Released 0.5 to 1.1 V
Depressed 2.6 to 4.5 V
Standard Voltage (Accele Sensor Out No. 2) Released 1.2 to 2.0 V
Depressed 3.4 to 4.75 V
MASS AIR FLOW METER SUB-ASSEMBLY
MAF

  • Engine not running

  • 30 seconds after engine switch turned on (IG)

0.53 gm/sec or less

(w/o Canister Pump Module)

0.54 gm/sec or less

(w/ Canister Pump Module)
Standard Resistance 1 (THA) - 2 (E2) -20 °C (-4 °F) 13.6 to 18.4 kΩ
20 °C (68 °F) 2.21 to 2.69 kΩ
60 °C (140 °F) 0.49 to 0.67 kΩ
CRANKSHAFT POSITION SENSOR
Standard Resistance Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω
ENGINE COOLANT TEMPERATURE SENSOR
Standard Resistance 20 °C (68 °F) 2.32 to 2.59 kΩ
80 °C (176 °F) 0.310 to 0.326 kΩ
KNOCK CONTROL SENSOR
Standard Resistance 20 °C (68 °F) 120 to 280 kΩ
AIR FUEL RATIO SENSOR
Standard Resistance

1 (HA1A) - 2 (+B)

1 (HA2A) - 2 (+B)

 20 °C (68 °F) 1.6 to 3.2 Ω

1 (HA1A) - 4 (A1A-)

1 (HA2A) - 4 (A2A-)

 Always 10 kΩ or higher
HEATED OXYGEN SENSOR
Standard Resistance

1 (HT1B) - 2 (+B)

1 (HT2B) - 2 (+B)

 20 °C (68 °F) 11 to 16 Ω

1 (HT1B) - 4 (E2)

1 (HT2B) - 4 (E2)

 Always 10 kΩ or higher
EFI INJECTION RELAY (INJ)
Standard Resistance 3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage is applied between terminals 1 and 2 Below 1 Ω
EFI 2 RELAY (EFI MAIN NO. 2)
Standard Resistance 3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage is applied between terminals 1 and 2 Below 1 Ω