ДАТЧИК ТОКА АККУМУЛЯТОРНОЙ БАТАРЕИ УСТАНОВКА

PROCEDURE


  1. INSTALL GENERATOR CONTROL ECU ASSEMBLY (BATTERY CURRENT SENSOR)


    1. Install the negative (-) battery terminal to the battery and tighten the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. A01V7CAN01

      Connect the generator control ECU assembly to the negative (-) battery terminal with nut A.

      Torque:
      7.6 N*m  { 77 kgf*cm, 67 in.*lbf }

    3. Connect the wire harness to the generator control ECU assembly with nut B.

      Torque:
      7.6 N*m  { 77 kgf*cm, 67 in.*lbf }

    4. Connect the connector to the generator control ECU assembly.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here