ДАТЧИК ТОКА АККУМУЛЯТОРНОЙ БАТАРЕИ СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. REMOVE GENERATOR CONTROL ECU ASSEMBLY (BATTERY CURRENT SENSOR)


    1. A01GD13N01

      Remove nut B and disconnect the No. 3 engine wire from the generator control ECU assembly.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    2. Disconnect the connector from the generator control ECU assembly.

    3. Remove nut A and disconnect the generator control ECU assembly from the negative (-) battery terminal.

    4. Loosen the nut and remove the negative (-) battery terminal from the battery.