СИСТЕМА ЗАРЯДКИ ДВИГАТЕЛЯ, Diagnostic DTC:P1602

DTC Code DTC Name
P1602 Deterioration of Battery

DESCRIPTION

The ECM monitors the battery. When the engine is running (not cranking) and the battery voltage drops below a specified level, the ECM determines that there is battery deterioration and stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P1602 Deterioration of Battery

Battery voltage is 11.85 V or less for 10 seconds or more when the engine is running (60 seconds elapses after the engine is started)

(1 trip detection logic)

  • Battery

  • Wire harness or connector

  • EFI-MAIN NO. 1 fuse

  • EFI NO. 3 fuse

 Does not come on DTC stored

WIRING DIAGRAM

A01V8LRE02
*a from Battery
*b EFI-MAIN NO. 1
*c EFI NO. 3

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1602)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Read the DTCs.


      Powertrain > Engine > Trouble Codes
      Result
      Proceed to
      DTC P1602 is output
      DTC P1602 and other DTCs are output

      Tech Tips

      If any DTCs other than P1602 are output, troubleshoot those DTCs first.


    DTC P1602 and other DTCs are output

    GO TO DTC CHART (FOR ECD SYSTEM) Click here

    DTC P1602 is output

  2. INSPECT CHARGING SYSTEM


    1. Check the charging system.

      Click here

      Result
      Result
      OK
      NG

    NG

    REPAIR OR REPLACE CHARGING SYSTEM

    OK

  3. CHECK HARNESS AND CONNECTOR (BATT POWER SOURCE)


    1. A01V8UXC01
      *a

      Front view of wire harness connector

      (to ECM)

      Disconnect the A61 ECM connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A61-2 (BATT) - Body ground Always 11 to 14 V
      Result
      Result
      OK
      NG

    OK

    CHECK FOR INTERMITTENT PROBLEMS Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR