PROCEDURE
- Click here
INSTALL TRANSAXLE CONTROL CABLE ASSEMBLY
-
Install the transaxle control cable assembly with the 2 bolts.
5.0 N*m 51 kgf*cm 44 in.*lbf -
Connect the transaxle control cable assembly to the control cable bracket, and install 2 new clips.
-
Connect the transaxle control cable assembly to the manual transaxle assembly, and install the 2 clips.
-
- Click here
CONNECT ENGINE WIRE
-
Connect the engine wire with bolt and clamp.
7.7 N*m 79 kgf*cm 68 in.*lbf
-
- Click here
INSTALL AIR CLEANER BRACKET
- Click here
INSTALL FRONT FLOOR COVER
- Click here
CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY
-
*1 Cable Lock *2 Lock Nut *a Push in - - Turn the lock nut of the transaxle control cable assembly 180° clockwise. While holding the lock nut in place, push in the stopper to lock the lock nut.
Note:Do not over-rotate the nut as it will come off the internal spring and the transaxle control cable assembly will not be reusable.
Tip:If the stopper cannot be pushed in, slightly turn the nut counterclockwise and then push in the cable lock again.
-
*1 Cable Lock *2 Lock Nut *3 Floor Shift Shift Lever Assembly - - Connect the outer part of the transaxle control cable assembly to the floor shift shift lever assembly. Check that the stopper returns to the pulled-out position.
-
*1 Slider *2 Lock Piece Slide the slider in the direction shown in the illustration and pull out the lock piece.
-
*1 Select Control Cable *2 Shift Control Cable Connect the shift control cable to the floor shift shift lever assembly.
-
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
-
Push the lock piece into the adjuster case and lock it.
Note:Make sure that the lock piece is completely locked by the slider.
-
Install a new clip to the select control cable.
Tip:Install a new clip.
-
- Click here
INSTALL REAR CONSOLE BOX SUB-ASSEMBLY