ПЕРВИЧНЫЙ ВАЛ ПОВТОРНАЯ СБОРКА

PROCEDURE


  1. INSTALL FRONT INPUT SHAFT BEARING


    1. A00YW27E01

      Using SST and press, press in the front input shaft bearing into the input shaft.

      SST
      09608-00071

  2. INSTALL INPUT SHAFT SNAP RING


    1. A00YWKV

      Using a brass bar and hammer, tap a new input shaft snap ring onto the input shaft.

  3. INSTALL 4TH GEAR


    1. A00YTRRE01

      Using SST and a press, press in the 4th gear into the input shaft.

      SST
      09309-14040

  4. INSTALL 3RD GEAR


    1. A00YRI9

      Install the spacer into the input shaft.

    2. A00YSEIE01

      Using SST and press, press in the 3rd gear into the input shaft.

      SST
      09309-14040

  5. INSTALL 6TH GEAR SUB-ASSEMBLY


    1. A00YR2FE01

      Using SST and press, press in the 6th gear sub-assembly into the input shaft.

      SST
      09309-14040

  6. INSTALL REAR INPUT SHAFT RADIAL BALL BEARING


    1. A00YQX3E01

      Using SST and press, press in the rear input shaft radial ball bearing into the input shaft.

      SST
      09506-30012

  7. INSTALL REAR INPUT SHAFT BEARING SHAFT SNAP RING


    1. A00YW1RC02
      *a Mark

      Select a new rear input shaft bearing shaft snap ring, using the table below, that makes the thrust clearance of the input shaft bearing less than 0.1 mm (0.00394 in.).

      Standard snap ring thickness
      Mark Specified Condition Mark Specified Condition
      A 1.80 mm (0.0708 in.) 3 2.20 mm (0.0866 in.)
      B 1.85 mm (0.0728 in.) 4 2.25 mm (0.0886 in.)
      C 1.90 mm (0.0748 in.) 5 2.30 mm (0.0906 in.)
      D 1.95 mm (0.0768 in.) 6 2.35 mm (0.0925 in.)
      E 2.00 mm (0.0787 in.) F 2.40 mm (0.0945 in.)
      0 2.05 mm (0.0807 in.) G 2.45 mm (0.0965 in.)
      1 2.10 mm (0.0827 in.) H 2.50 mm (0.0984 in.)
      2 2.15 mm (0.0846 in.) - -
    2. A00YU59

      Using a snap ring expander, install the rear input shaft bearing shaft snap ring into the input shaft.